Intel Pushes New SSD Toolbox, Updates 335 Series Firmware MWI Bug

Subject: Storage | November 28, 2012 - 10:32 PM |
Tagged: ssd toolbox, Intel, firmware, 335

A quick note to users of Intel SSDs - specifically for owners of the 335 Series. Intel has updated their SSD Toolbox app to v3.1.2. This app is used for various tasks on Intel SSDs, such as secure erasure, performance optimization under Windows, and TRIM through RAID-0 under Intel RST / ICH / PCH motherboard SATA controllers. This update is significant in that it can in turn update the firmware of the Intel 335 Series SSDs to correct a bug in how those drives report wear. This bug was initially discovered by Kristian Vättö, over at Anandtech.

View Full Size

If you have a newer version of the SSD Toolbox, F9 will be listed as "Total NAND Writes", and list that value in MB. The issue with the original 335 firmware was that it incorrectly calculated the wear (the Wearout Indicator - E9 above) such that it would list the drive as worn out after ~1,000 total flash cell erase cycles (i.e. 1,000 x the capacity of the SSD). The firmware update corrects this value to ~3,000 cycles, which is more appropriate for the rating of IMFT 20nm flash. Updating should be non-destructive, but you should backup just in case. The update is not urgent, in that it only corrects how the drive does the math to calculate E9. The Wearout Indicator will change to the correct value after the update, regardless of when it is applied. Additionally, if the MWI reaches 0 prematurely, it should have no impact on operation of the SSD.

Grab the update here.