Introduction and Packaging
Last October, Western Digital launched the My Cloud. This device was essentially a network connected version of their My Book line of external hard drives, but with Internet connectivity and apps that could reach back to the My Cloud even when you were away from home. One month later, WD launched the My Cloud EX4, a much beefier version which supported redundant arrays of 4 hard disks, redundant network and power, and a load of other features. There was a rather large gap in features between these two devices, as the only RAID option was more of a small business one. Today Western Digital closed that gap:
The My Cloud EX2 is essentially a My Cloud, but with dual drive bays, and a few additional features. Check out this projected trend below:
You can see there was a definite void in the 2-drive range that needed filling. With those two drives, you get a few options for redundancy or capacity+speed:
All standard RAID options for a 2-bay appliance are met here, though the vast majority of users should opt for the default RAID-1 mirrored set.
Packaging is simple here with only a power adapter, ethernet cable, and quick start guide needed.
Introduction and Features
Today Western Digital launched an important addition to their Personal Cloud Storage NAS family - the My Cloud EX4:
The My Cloud EX4 is Western Digital's answer to the increased demand for larger personal storage devices. When folks look for places to consolidate all of their bulk files, media, system backups, etc, they tend to extend past what is possible with a single hard drive. Here is Western Digital's projection on where personal storage is headed:
Where the My Cloud was a single drive solution, the My Cloud EX4 extends that capability to span up to four 3.5" drives. When it comes to devices that span across several drives, the number 4 is a bit of a sweet spot, as it enables several RAID configurations:
Everything but online capacity expansion (where the user can swap drives one at a time to a larger capacitiy) is suppoted. While WD has stated that feature will be available in a future update, I find it a bit risky to intentionally and repeatedly fail an array by pulling drives and forcing rebuilds. It just makes more sense to back up the data and re-create a fresh array with the new larger drives installed.
Ok, so we've got the groundwork down with a 4-bay NAS device. What remains to be seen is how Western Digital has implemented the feature set. There is a lot to get through here, so let's get to it.