Subject: Storage
Manufacturer: Intel

Introduction and Specifications

Back in April, we finally got our mitts on some actual 3D XPoint to test, but there was a catch. We had to do so remotely. The initial round of XPoint testing done (by all review sites) on a set of machines located on the Intel campus. Intel had their reasons for this unorthodox review method, but we were satisfied that everything was done above board. Intel even went as far as walking me over to the very server that we would be remoting into for testing. Despite this, there were still a few skeptics out there, and today we can put all of that to bed.

DSC01136.jpg

This is a 750GB Intel Optane SSD DC P4800X - in the flesh and this time on *our* turf. I'll be putting it through the same initial round of tests we conducted remotely back in April. I intend to follow up at a later date with additional testing depth, as well as evaluating kernel response times across Windows and Linux (IRQ, Polling, Hybrid Polling, etc), but for now, we're here to confirm the results on our own testbed as well as evaluate if the higher capacity point takes any sort of hit to performance. We may actually see a performance increase in some areas as Intel has had several months to further tune the P4800X.

This video is for the earlier 375GB model launch, but all points apply here
(except that the 900P has now already launched)

Specifications:

specs.png

The baseline specs remain the same as they were back in April with a few significant notable exceptions:

The endurance figure for the 375GB capacity has nearly doubled to 20.5 PBW (PetaBytes Written), with the 750GB capacity logically following suit at 41 PBW. These figures are based on a 30 DWPD (Drive Write Per Day) rating spanned across a 5-year period. The original product brief is located here, but do note that it may be out of date.

We now have official sequential throughput ratings: 2.0 GB/s writes and 2.4 GB/s reads.

We also have been provided detailed QoS figures and those will be noted as we cover the results throughout the review.

Read on for our review of the 750GB P4800X!

Intel Officially Kicks Off Optane Launch with SSD DC P4800X

Subject: Storage | March 19, 2017 - 12:21 PM |
Tagged: XPoint, SSD DC P4800X, Optane Memory, Optane, Intel, client, 750GB, 3D XPoint, 375GB, 1.5TB

Intel brought us out to their Folsom campus last week for some in-depth product briefings. Much of our briefing is still under embargo, but the portion that officially lifts this morning is the SSD DC P4800X:

Intel_SSD_4800_FlatFront_OnWhite_RGB_Small.jpg

optane-4.png

optane-9.png

MSRP for the 375GB model is estimated at $1520 ($4/GB), which is rather spendy, but given that the product has shown it can effectively displace RAM in servers, we should be comparing the cost/GB with DRAM and not NAND. It should also be noted this is also nearly half the cost/GB of the X25-M at its launch. Capacities will go all the way up to 1.5TB, and U.2 form factor versions are also on the way.

For those wanting a bit more technical info, the P4800X uses a 7-channel controller, with the 375GB model having 4 dies per channel (28 total). Overprovisioning does not do for Optane what it did for NAND flash, as XPoint can be rewritten at the byte level and does not need to be programmed in (KB) pages and erased in larger (MB) blocks. The only extra space on Optane SSDs is for ECC, firmware, and a small spare area to map out any failed cells.

Those with a keen eye (and calculator) might have noted that the early TBW values only put the P4800X at 30 DWPD for a 3-year period. At the event, Intel confirmed that they anticipate the P4800X to qualify at that same 30 DWPD for a 5-year period by the time volume shipment occurs.

Read on for more about the SSD DC P4800X (and other upcoming products!)