Western Digital Red 3.5" 4TB and 2.5" 1TB NAS HDD Full Review - WD Red Mini?
Specs, Testing Methodology and System Setup
Here's my translation of Western Digital's marketing speak for the specs of the WD Red Series. Some of these are not specifically listed by WD, but we know they are in there, so we will keep them here for your education:
- NoTouch™ ramp load technology — Previously called "IntelliPark". Drive heads take an 'exit ramp' off of the platters instead of landing on the platters when the drive is spun down. You know how the most damage is done to your engine when you start it on a cold morning? This means the drive heads do not have to break stiction each and every time the drive spins up. The heads are able to leave the ramp and float onto the spinning disk.
- Native Command Queuing (NCQ) — The drive can reorder groups of reads/writes to minimize overall head movement, and therefore increase effective access time. Beware - this is only effective with an AHCI-enabled SATA controller.
- Perpendicular Magnetic Recording (PMR) — Bits are aligned vertically instead of horizontally to get more packed onto each platter. Think dominoes (the game, not the food).
- 64MB cache — Basically standard across most current WD models, though this part is faster than those previous. Increased cache speed helps boost random access performance.
- Dual processors — Introduced with the RE4-GP line, the additional core helps the drive keep track of the added cache and increased throughput streaming off of the head pack.
- Advanced Format — Introduced back in late 2009, this increases storage efficiency and robustness by having the drive handle data as 4KB internal blocks. This means error correction routines are not limited to 512B segments. ECC works better on larger chunks of data, and this gives an ~50% improvement in that area. The trade-off is random access for blocks <4KB will suffer, but this is not much of an issue as the vast majority of file access is >= 4KB.
Now for the standouts:
- RAID-specific time-limited error recovery (TLER) — The drive limits the 'hang' experienced on a read error in order to avoid a RAID controller considering the drive dead / offline.
- 3D Active Balance Plus — Our enhanced dual-plane balance control technology significantly improves the overall drive performance and reliability. Hard drives that are not properly balanced may cause excessive vibration and noise in a multi-drive system, reduce the hard drive life span, and degrade the performance over time.
The WD Active Balance tech does a good job to make the drive as vibration free and therefore as quiet as possible during operation. This is particularly handy when you have several of them stacked in a relatively lighweight NAS enclosure.
The load/unload spec (for the ramp load technology) remains at 600,000 cycles.
Specific to this Review
The Red was tested under our Sandy Bridge test bed as the Ivy Bridge was busy doing some dynamic SSD testing. PC Perspective would like to thank ASUS, Corsair, and Kingston for supplying some of the components of our test rig.
|Hard Drive Test System Setup|
|CPU||Intel Core i5-2500K|
|Motherboard||Asus P8Z68-V Pro|
|Memory||Kingston HyperX 4GB DDR3-2133 CL9|
|Hard Drive||G.Skill 32GB SLC SSD|
|Video Card||Intel® HD Graphics 3000|
|Power Supply||Corsair CMPSU-650TX|
|Operating System||Windows 7 X64|
- HDTach *omitted due to incompatibility with 3TB devices*
- PCPer File Copy Test