Review Index:
Feedback

SilverStone Strider Gold Evolution 1000W Power Supply Review

Efficiency, Differential Temperature and Noise

Efficiency

The overall efficiency of a power supply is very important, especially when the power supply is designed to deliver over 1,000W DC output. The less waste heat generated the better! Efficiency is defined by the power output divided by the power input and is usually expressed as a percentage. If a PSU were a 100% efficient (which none are) 1,000 watts of AC power going in would result in 1,000 watts of DC power coming out (with no waste heat to dissipate). In the real world there are always inefficiencies and power is lost in the form of heat during the conversion process.

View Full Size

The latest revisions to the ATX12V Power Supply Design Guide V 2.2 have continued to increase the efficiency recommendations for PC switching mode power supplies and now lists both required and recommended minimum efficiencies.

View Full Size

I measured the AC power input to the Strider Gold Evolution 1000W PSU with the Extech power analyzer while the total DC load was found by adding all the individual +3.3V, +5V, +12V, -12V and +5VSB loads together.

View Full Size

View Full Size

The SilverStone Strider Gold Evolution 100W PSU is certified 80 Plus Gold, which means it should produce at least 87% efficiency while delivering between 20% and 100% load and at least 90% efficiency at 50% load. During our tests the PSU was able to easily meet these requirements, even while operating at elevated, real-world operating temperatures.

Note that efficiency will almost always be higher at the 240 VAC line voltage versus 115 VAC (as the voltage goes up the current goes down, and since line/component loses are proportional to current, less current means lower loses).

80 Plus Program

View Full Size

Note 1: Power Factor =0.90 (50% to 100% Load)
Note 2: Tests conducted at room temperature (25°C)

Spending a little more money up front to purchase a high efficiency power supply may very well help pay for itself over the lifetime of the PC, especially if you are using this much power… :)

Differential Temperature and Noise Levels

To simulate real world operation the Strider Gold Evolution 1000W power supply was mounted in a modified mid tower case (Lian Li PC60) during testing. Some of the warm exhaust air from the PSU under test is recirculated back into the case, which allows the internal case air temperature to increase with load, just like it would in a real PC. The internal case air temperature is allowed to increase up to 40ºC and then held constant from then on at 40ºC.

The differential temperature across the power supply was calculated by subtracting the internal case air temperature (T in) from the temperature of the warm exhaust air flowing out the back of the power supply (T out).

Thermocouples were placed at the air inlet and exhaust outlet. The ambient room air temperature was 23ºC (74ºF) +/- 0.5ºC during testing.

T out = temperature of air exhausting from power supply
T in = temperature of air entering power supply
Delta T = T out - T in

Sound pressure level readings were taken 3’ away from the rear of the case in an otherwise quiet room. The ambient noise level was ~28 dBA.

View Full Size

Below 600W output and with a relatively cool ambient inlet air temperature, the Strider Gold Evolution 1000W PSU is very quiet; virtually silent. After that, as the load increases and temperatures build, the cooling fan speeds up to where it becomes noticeable but never really loud. Having high efficiency helps with less waste heat to dissipate.

Note: I was not able to take SPL readings at the higher loads due to all the programmable DC load cooling fans running in the background.

View Full Size

(Courtesy of SilverStone)
 

April 3, 2012 | 02:29 PM - Posted by pdjblum

Nicely done indeed.

I would still go with a Seasonic, though it is nice to have other very high quality psu's to choose from.

Post new comment

The content of this field is kept private and will not be shown publicly.
  • Lines and paragraphs break automatically.
  • Allowed HTML tags: <a> <em> <strong> <cite> <code> <ul> <ol> <li> <dl> <dt> <dd> <blockquote><p><br>
  • Web page addresses and e-mail addresses turn into links automatically.

More information about formatting options

By submitting this form, you accept the Mollom privacy policy.