Review Index:
Feedback

Seasonic S12G Series 750W Power Supply Review

Manufacturer: Seasonic

DC Load Regulation and AC Ripple

DC Output Load Regulation

To simulate real world and maximum loading conditions, the Seasonic S12G-750  PSU was connected to the load testers and supplied with a constant 115 VAC.  In this test we are interested in seeing how well a PSU can maintain the various output voltages while operating under different loads.  

The ATX12V V2.2 tolerance for voltages states how much each output (rail) is allowed to fluctuate and has tighter tolerances now for the +12V outputs.  I have also included a second table of expanded tolerances (±1% to ±6%) for reference.

View Full Size

The following tables list the DC voltage results for the PSU while operating on 115 VAC, 60 Hz.

View Full Size

As you can see, the S12G-750 PSU produced excellent load regulation on all of the outputs across a broad range of loads.  The three primary outputs stayed within ±2% of target, which is excellent.

View Full Size

AC Ripple and Noise on the DC Outputs

The amount of AC ripple and noise present on the DC outputs was checked using a digital oscilloscope.  This AC component may be present in the KHz range where most switching power supplies operate or it may be more prevalent at the 60 Hz line frequency.  We adjust the O-scope time base to look for AC ripple at both low and high frequencies.  The ATX12V V2.2 specification for DC output noise/ripple is defined in the ATX12V Power Supply Design Guide.

View Full Size

Ideally we would like to see no AC ripple (repetitive) or noise (random) on the DC outputs – the cleaner the better!  But in reality there will always be some present.  I measured the amplitude of the AC signal (in millivolts, peak-to-peak) to see how well the power supply complied with the ATX standard.  The following table lists the ripple/noise results during all of the load tests for the main output voltages of interest.

View Full Size

The Seasonic S12G-750 power supply exhibited very good AC ripple suppression on all of the primary outputs and stayed well below the recommended values, even at full load.

December 26, 2013 | 12:42 PM - Posted by Anonymous (not verified)

The short length (140 mm) would make this a good PS for a mATX case with SLI or Crossfire.

Post new comment

The content of this field is kept private and will not be shown publicly.
  • Lines and paragraphs break automatically.
  • Allowed HTML tags: <a> <em> <strong> <cite> <code> <ul> <ol> <li> <dl> <dt> <dd> <blockquote><p><br>
  • Web page addresses and e-mail addresses turn into links automatically.

More information about formatting options

By submitting this form, you accept the Mollom privacy policy.