Review Index:
Feedback

Innovatek Reservoir Review

Author: Ryan Shrout
Manufacturer: General
Tagged:

Description

This content was originally featured on Amdmb.com and has been converted to PC Perspective's website. Some color changes and flaws may appear.

The Innovatek reservoir from HighSpeed PC comes in two flavors: a clear Plexiglas tank, which would look great with some L.E.D’s, or an anodized black aluminum tank.



Both tanks consist of a small block of either material with an internal cylindrical chamber approximately 1 inch across by 3 inches deep. Near the top of the Reservoir is an 8mm Stainless steel compression fitting that attaches to the return line. [Due to the nature of the 8mm fittings, thin walled 8mm tubing is required although I’m sure a modification could be made for larger hoses] By the base of the tank in the side wall is a larger opening with two O rings inside. These O rings seal water tight to intake shaft on either the Ehiem 1046 or 1048 pumps. Note: I found that smearing a drop of dish soap on the impeller housing made it much easier to slide the reservoir in place, just make sure to rinse it off afterwards. The reservoir is filled at the top and is sealed watertight by a large plastic cap which screws tightly against an O ring.



No comments posted yet.

Post new comment

The content of this field is kept private and will not be shown publicly.
  • Lines and paragraphs break automatically.
  • Allowed HTML tags: <a> <em> <strong> <cite> <code> <ul> <ol> <li> <dl> <dt> <dd> <blockquote><p><br>
  • Web page addresses and e-mail addresses turn into links automatically.

More information about formatting options

By submitting this form, you accept the Mollom privacy policy.