Review Index:
Feedback

Corsair HX1050 Professional Series Power Supply Review

Manufacturer: Corsair

Efficiency, Differential Temperature and Noise

Efficiency

The overall efficiency of a power supply is very important, especially when the power supply is designed to deliver over 1,000W DC output. The less waste heat generated the better! Efficiency is defined by the power output divided by the power input and is usually expressed as a percentage. If a PSU were a 100% efficient (which none are) 1,000 watts of AC power going in would result in 1,000 watts of DC power coming out (with no waste heat to dissipate). In the real world there are always inefficiencies and power is lost in the form of heat during the conversion process.

View Full Size

The latest revisions to the ATX12V Power Supply Design Guide V 2.2 have continued to increase the efficiency recommendations for PC switching mode power supplies and now lists both required and recommended minimum efficiencies.

View Full Size

I measured the AC power input to the Corsair HX1050PSU with the Extech power analyzer while the total DC load was found by adding all the individual +3.3V, +5V, +12V, -12V and +5VSB loads together.

View Full Size

View Full Size

The Corsair Professional Series HX1050PSU is certified 80 Plus Silver, which means it should produce at least 85% efficiency while delivering between 20% and 100% load and at least 88% efficiency at 50% load. The HX1050 PSU easily met these requirements, even when operating at real world operating temperatures, which typically lowers efficiency. Overall, very good results.

Note that efficiency will almost always be higher at the 240 VAC line voltage versus 115 VAC (as the voltage goes up the current goes down, and since line/component loses are proportional to current, less current means lower loses.

80 Plus Program

There is a growing awareness among users, PC manufacturers and electric utilities regarding the money and natural resources that could be saved by adopting higher efficiency PC power supplies. One group that is spearheading this movement is the 80 Plus Program, which is supported by the electric utilities industry. You can learn more about their efforts to promote power supplies with better than 80% efficiency by visiting the 80 Plus Program website.

View Full Size

Note 1: Power Factor ≥0.90 (50% to 100% Load)
Note 2: Tests conducted at room temperature (25°C)

Spending a little more money up front to purchase a high efficiency power supply may very well pay for itself over the lifetime of the PC, especially when you are using this much power… :)

Differential Temperature and Noise Levels

To simulate real world operation the Corsair Professional Series HX1050power supply was mounted in a modified mid tower case (Lian Li PC60) during testing. Some of the warm exhaust air from the PSU under test is recirculated back into the case, which allows the internal case air temperature to increase with load, just like it would in a real PC. The internal case air temperature is allowed to increase up to 40ºC and then held constant from then on at 40ºC.

The differential temperature across the power supply was calculated by subtracting the internal case air temperature (T in) from the temperature of the warm exhaust air flowing out the back of the power supply (T out).

Thermocouples were placed at the air inlet and exhaust outlet. The ambient room air temperature was 23ºC (74ºF) +/- 0.5ºC during testing.

T out = temperature of air exhausting from power supply
T in = temperature of air entering power supply
Delta T = T out - T in

Sound pressure level readings were taken 3’ away from the rear of the case in an otherwise quiet room. The ambient noise level was ~28 dBA.

View Full Size

Below 600W output and with a relatively cool ambient inlet air temperature, the Corsair Professional Series HX1050 PSU is very quiet. After that, as the load increases and temperatures build, the cooling fan speeds up to where it becomes noticeable but never really loud. Having high efficiency helps with less waste heat to dissipate.

Note: I was not able to take SPL readings at the higher loads due to all the programmable DC load cooling fans running in the background.
 

October 19, 2011 | 12:10 PM - Posted by Anonymous (not verified)

If the components & construction are all that, then why no Platinum certification?

October 2, 2012 | 09:43 AM - Posted by Fananora (not verified)

Bonne alim pour ma config.
Boitier: Pc Gamer Hunter X Rouge
CPU: Intel Core i7 870
GPU: Club 3D GeForce GTX 570 1,25 Go CoolStream Edition x2 en Sli
Alimentation: Corsair HX – 1050W
Carte Mère : ASRock P55-Deluxe
Ram: CORSAIR Vengeance LP 4x4 Go DDR3-1600 - PC3-12800
Lecteurs : Blu-Ray + Lecteur Cd-rom

Post new comment

The content of this field is kept private and will not be shown publicly.
  • Lines and paragraphs break automatically.
  • Allowed HTML tags: <a> <em> <strong> <cite> <code> <ul> <ol> <li> <dl> <dt> <dd> <blockquote><p><br>
  • Web page addresses and e-mail addresses turn into links automatically.

More information about formatting options

By submitting this form, you accept the Mollom privacy policy.