Be Quiet! Power Zone 1000W Power Supply Review
Efficiency, Differential Temperature and Noise
Efficiency is defined by the power output divided by the power input and is usually expressed as a percentage. If a PSU were a 100% efficient (which none are) 700 watts of AC power going in would result in 700 watts of DC power coming out (with no waste heat to dissipate). In the real world there are always inefficiencies and power is lost in the form of heat during the conversion process. Newer revisions to the ATX12V Power Supply Design Guide V 2.2 have continued to increase the efficiency recommendations for PC switching mode power supplies and now lists both required and recommended minimum efficiencies.
We measured the AC power input to the Power Zone 1000W PSU with an Extech power analyzer while the total DC load was found by adding all the individual +3.3V, +5V, +12V, -12V and +5VSB loads together.
The overall efficiency of the Power Zone 1000W power supply is very good and easily exceeded the criteria for 80Plus Bronze certification, even while operating on 115 VAC and at elevated temperatures. Our test sample nearly met the requirements for 80Plus Gold!
80 Plus Program
Note 1: Power Factor =0.90 (50% to 100% Load)
Note 2: Tests conducted at room temperature (25°C)
Differential Temperature and Noise Levels
To simulate real world operation, some of the warm exhaust air from the PSU under test is recirculated back to the intake through a passive air duct, which allows the PSU air inlet temperature to increase with load, just like it would in a real PC.
The differential temperature across the power supply was calculated by subtracting the internal case air temperature (T in) from the temperature of the warm exhaust air flowing out the back of the power supply (T out).
Thermocouples were placed at the air inlet and exhaust outlet. The ambient room air temperature was 23ºC (74ºF) +/- 0.5ºC during testing.
T out = temperature of air exhausting from power supply
T in = temperature of air entering power supply
Delta T = T out - T in
Sound pressure level readings were taken 3’ away from the rear of the case in an otherwise quiet room. The ambient noise level was ~28 dBA. I was not able to take SPL readings at the higher loads due to the background noise generated by all the DC Load cooling fans cycling on and off.
At low to mid power levels (10-50% load) the cooling fan was very quiet. Even when delivering 500W (50% load) the cooling fan noise was barely detectable. I was not able to measure the SPL at the max load due to all the programmable DC load cooling fans cycling on and off, but subjectively the fan gets very noticeable at full load.
Get notified when we go live!