All | Editorial | General Tech | Graphics Cards | Networking | Motherboards | Cases and Cooling | Processors | Chipsets | Memory | Displays | Systems | Storage | Mobile | Shows and Expos
Subject: Memory | May 29, 2007 - 01:06 PM | Jeremy Hellstrom
Kingston has announced it's new lineup of low(er) latency DDR3. The timings available on DRR3 will take some getting used to, as even these tightly timed DIMMs look sloppy compared to high end DDR2, but the as the actual clockspeed increases, those timings won't seem so bad. The modules AnandTech tested are rated at DDR3-1375 @ 7-7-7-20, and when they were clocked up to 1520 @ 8-8-8-22 they left Corsair's Dominators in the dust.
Subject: Memory | May 24, 2007 - 04:56 PM | Jeremy Hellstrom
If you are curious as to what the difference between DDR2 and DDR3 is, OCModShop has published the perfect article for you. The increase in maximum speed is the real difference, but if you are looking to find out how that is achieved, and why DDR2 can't just keep be pushed faster then dig into the article.
Subject: Memory | May 23, 2007 - 11:35 AM | Jeremy Hellstrom
Sunnyvale, Calif. May 22, 2007 OCZ Technology Group, a worldwide leader in innovative, ultra high performance and high reliability memory, today announced their official crossover into DDR3 memory to coincide with the recent launch of the Intel Bearlake Chipset. OCZ's hand tested DDR3 solutions enable ardent enthusiasts to take advantage of the highly anticipated P35 platform while experiencing the legendary quality and reliability of OCZ memory.
Subject: Memory | May 22, 2007 - 02:58 PM | Jeremy Hellstrom
The new Reaper series from OCZ really impressed Overclockers Online. Running at 1150 @ 5-5-5-18 straight out of the box they are some of the fastest chips, period. The new cooling solution both adds style to the DIMMs as well as some very good cooling. Once they got down to testing, they found limitations in tightening the timings, but by keeping the timings at the rated intervals, they could get a nice jump in speed.
"The performance of these Reaper HPCs at 5-5-5 certainly was br
Subject: Memory | May 16, 2007 - 02:40 PM | Jeremy Hellstrom
AnandTech has grabbed 2 DIMMs of DDR3-1066 running at 7-7-7-20 and an ASUS P5K3 Deluxe. The contrast that pairing with an ASUS P5B Deluxe and Corsair's Dominator DDR2-1111. They varied the speeds to get a better idea of performance, unfortunately there are no DDR3-1333 DIMMs available yet, but when they are they will revisit the test to see what effect the raw speed has. Is timing everything?
Subject: Memory | May 10, 2007 - 02:27 PM | Jeremy Hellstrom
Gone are the days when there was a 4GB limit on addressable memory because of the limitations of 32-bit processors. WinXP and Vista both come in 64-bit version which has a theoretical limit of 16,000,000 GB of RAM
Subject: Memory | May 8, 2007 - 01:00 PM | Jeremy Hellstrom
Sunnyvale, Calif.-May 7, 2007-OCZ Technology, a worldwide leader in
innovative, ultra-high performance and high reliability memory, today
unveiled a unique memory kit for AMD enthusiasts and power users. The new
PC2-5400 Titanium modules were designed exclusively for the AMD AM2 platform
and are custom-tailored to the extended column address range of the AM2
memory controller. With a doubled page size, access penalties are reduced to
ultimately improve system performance.
Subject: Memory | May 4, 2007 - 01:31 PM | Jeremy Hellstrom
3dGameMan has posted a review of Mushkin's new 4GB kit of PC2-6400 memory with timings of 5-4-4-12. These kits aren't just for gaming, although you will benefit from it, it also helps you to run Vista with better response. If you are an overclocker, there is something even nicer about these DIMMs, they bumped the voltage to 2.2, kept the timings the same and managed to hit 1068MHz.
Subject: Memory | April 30, 2007 - 02:51 PM | Jeremy Hellstrom
OCZ's 2GB PC2-9200 Reaper HPC kit is designed for speed and quiet at the same time. The DIMMs are totally covered in a black heatspreader that has a heat pipe running along the top, and extends to another heatspreader located above the DIMM, attached only by the heatpipe. It is timed @ 5-5-5-18 out of the box, and is capable of 642MHz at those timings.
Subject: Memory | April 25, 2007 - 03:03 PM | Jeremy Hellstrom
SANTA CLARA, Calif. and BOISE, Idaho, April 25, 2007 — Intel Corporation and Micron Technology, Inc., today announced they are sampling industry-leading 50 nanometer (nm) multi-level cell (MLC) NAND flash memory manufactured by their NAND flash memory joint venture, IM Flash Technologies.
Subject: Memory | April 24, 2007 - 06:32 PM | Jeremy Hellstrom
Super Talent's T1000UX2G5 2GB PC2-8000 DDR2 offers great potential, with a 20% overclock possible using the default timings, or you can tighten the timings at 1000MHz. Big Bruin did find little difference between that and the reference PC2-6400 they tested it against, which costs about 1/2 as much. Don't let that deter you from reading the full review, as these DIMMs will allow you more flexibility when
Subject: Memory | April 19, 2007 - 05:45 PM | Jeremy Hellstrom
Over at Techware Labs, OCZ's PC2 7200 SLI-Ready 2Gb kit is on the test bench. This RAM may be fast out of the package, but they couldn't say they'd fully tested it without a good overclock, and in this case 1200MHz @ 5-5-5-18 timings by bumping the voltage to 2.4 was the best they could get. Add some active cooling and you may even go beyond.
Subject: Memory | April 18, 2007 - 03:03 PM | Jeremy Hellstrom
Sunnyvale, CA-April 17, 2007-OCZ Technology Group, a worldwide leader in
innovative, ultra-high performance and high reliability memory, today
announced the PC2-9600 Flex XLC series. The latest edition to OCZ's esteemed
enthusiast lineup implements the proprietary Flex XLC design and is
engineered to produce extreme speeds with rock-solid stability. The PC2-9600
Flex modules are guaranteed to run at 1200MHz with ease thanks to the
supreme component screening and thermal management of "Flex."
Subject: Memory | April 13, 2007 - 12:22 PM | Jeremy Hellstrom
Mushkin's XP2-9200 runs at 1150MHz @ 5-5-4-12 out of the box, and Overclocker's Club pushed it to 1200MHz without any effort at all. With a different board and a bump in voltage, these DIMMs can probably go even further. As this RAM will keep up with any processor on the market right now, it lets you take full advantage of a 1:1 ratio between RAM and CPU.
"You know the drill: countless hours spent in front of the magic box, doing research trying to get the most performance for
your hard earned dollar
Subject: Memory | March 30, 2007 - 01:16 PM | Jeremy Hellstrom
HotHardware has posted a review of Corsair's newest Dominator, the TWIN2X2048-10000C5DF. It is a pair of 1GB DIMMs running at PC2-10000 DIMMs with timings of 5-5-5-18-2T at 1250MHz, and sports the Dominator cooling fans and shroud. Because this is pretty much the fastest RAM going, there isn't much room for OCing, but it does come out king in
Subject: Memory | March 20, 2007 - 02:47 PM | Jeremy Hellstrom
CellShock and MSC GmbH are probably not names that spring to mind when someone is talking about RAM. However, they have been active in Europe for over 20 years. Legit Reviews takes a look at their DDR2 1000 2GB kit. The DIMMS have a good heatsink, use Micron D9GKX IC's, live on an 8 layer PCB and can hold their own against Corsair.
Subject: Memory | March 15, 2007 - 01:10 PM | Jeremy Hellstrom
Legion Hardware sets out to solve a mystery in this article about low latency RAM. The cost difference between a lower latency DIMM and a higher can be enormous, so they test RAM at 5 different speeds and 4 different timings. Can a high frequency overcome a low latency?
Subject: Memory | March 8, 2007 - 03:07 PM | Jeremy Hellstrom
X-bit Labs reviews the Acer Aspire 9300, a Turion X2 based machine coupled with Nvidia nForce Go 430 MCP and Nvidia GeForce Go 6100 chipset plus an onboard 7600 Go SE. It is not going to keep up with an Alienware machine, but the combined battery life, and the price/performance ratio might just tempt quite a few people.
Subject: Memory | February 28, 2007 - 03:03 PM | Jeremy Hellstrom
Corsair's DOMINATOR Twin2X2048-8888C4DF runs at 1111 MHz with timings of 4-4-4-12. They have Corsair's newly designed heatspreaders, and the DOMINATOR Airflow fan bracket is optional. Thanks to this efficient cooling scheme, 1244 MHz at 4-4-4-12 is reachable, if the voltage is bumped to 2.5V. Be prepared to pay for this performance though, these modules will set you back more than $700. Re
Subject: Memory | February 27, 2007 - 12:56 PM | Jeremy Hellstrom
San Jose, California — February 27, 2007 -- Super Talent Technology, a leading manufacturer of DRAM memory modules and flash products, today announced that their 800MHz DDR2 modules have passed ATI CrossFire Certification.
Get notified when we go live!