A little DIY hard drive unbricking

Subject: Storage | July 30, 2012 - 01:31 PM |
Tagged: Seagate, repair, DIY, bricked

While this trick will not work on all bricked HDDs, if you have a Seagate 7200.11 HDD that is failing because it is convinced it is always in a busy state then you should check out this story on Hack a Day.  While the initial step of detaching the circuit board and blocking some connections with piece of cardstock can be handled with easy, it will take some expertise to use an Arduino or serial-TTL converter to issue commands to the HDD controller.  It is a good thing that there is a tutorial to walk you through the steps to unbrick your HDD, besides in the worst case scenario your HDD will still be a brick so it is worth a shot.

View Full Size

"Hard drive firmware is about the last place you want to find a bug. But that turned out to be the problem with the Seagate HDD which he was using in a RAID array. It stopped working completely, and he later found out the firmware has a bug that makes the drive think it’s permanently in a busy state. There’s a firmware upgrade available, but you have to apply it before the problem shows its face, otherwise you’re out of luck. Some searching led him to a hardware fix for the problem."

Here are some more Storage reviews from around the web:

Storage

Source: Hack a Day
July 31, 2012 | 09:09 AM - Posted by Anonymous (not verified)

spammmmmmmmmmmmmmmmmmm

August 1, 2012 | 12:13 PM - Posted by Jeremy Hellstrom

not any more

Post new comment

The content of this field is kept private and will not be shown publicly.
  • Lines and paragraphs break automatically.
  • Allowed HTML tags: <a> <em> <strong> <cite> <code> <ul> <ol> <li> <dl> <dt> <dd> <blockquote><p><br>
  • Web page addresses and e-mail addresses turn into links automatically.

More information about formatting options

By submitting this form, you accept the Mollom privacy policy.