ECS Motherboards on display at Computex 2011
Subject: Motherboards, Shows and Expos | June 4, 2011 - 10:42 PM | Ryan Shrout
Tagged: x79, fusion, ECS, e-350, computex, 990fx
ECS, aka Elitegroup, had a large booth at Computex that focused more on its ODM aspects than consumer aspects, but there were still a couple of interesting designs to look at.
The board we spotted was the new A990FXM-A motherboard that is of course based on the latest 990FX chipset from AMD. Supporting the AM3+ processor socket and thus the pending AMD Bulldozer processors, the 990FX is going to be a long term product rather than a short term. One interesting addition to the board is found on the chipset heatsink that has a temperature reactive plastic on it that will turn from grey to orange-ish as the ambient case temperature increases. This could be a great feature to easily gauge the heat level inside a windowed case.
Also an interesting move, ECS has elongated the receptacle on the 8-pin CPU power connection to make it easier to plug in and to remove. If you have ever experienced a pinched finger or sliced finger nail from trying to reach down and unplug an ATX connector, you will see this as a nice addition.
ECS also had its X79 motherboard variant on display, showing the company's readiness for the pending Sandy Bridge-E release.
Also on the motherboard wall was the upcoming A75F-A with support for the AMD Llano Fusion-based processors that should be ready later in the summer.
Finally, a motherboard that we have just recently received for review purposes, the HDC-I is an AMD E-350 or E-240 Zacate platform mini-ITX form factor. This solution might be a great option for users looking to build an HTPC box so be sure you check out our full review coming shortly.