Newegg sent along word about their latest Case Mod contest winners.  The winner built a PC in a Ford Bronco model

So I started making a model out of clay and spent about 3 months getting it right. I found a 12.1” LCD screen on EBay for $100 that was just the right size for under the hood. After the clay was done and all measurements checked out I made a rubber mold. I then formed the computer case in the rubber mold with fiberglass, which I had only worked with a little bit on car body repairs. This was a lot different and took some experimenting to get the hang of it. Luckily it did come out of the mold fairly good on the first try. After getting the fiberglass case out of the mold, I used bondo to fill all the little air holes followed by lots and lots of sanding.