The Ice Wind Pro is a breeze to install

Subject: Cases and Cooling | May 24, 2012 - 01:57 PM |
Tagged: Deepcool, Ice Wind Pro, heatsink

One neglected feature of heatsinks has always been the ease of installation, which has become much worse now that many heatsinks are so heavy they require a backplate to prevent its weight from damaging your socket or motherboard.  For those who would prefer a heatsink that can be installed without needed to access the back of the motherboard, or even removing the board from its case, DeepCool's Ice Wind Pro might be a good choice.  At 650g it is light compared to many other models and the handy bracket offers more than enough support for that weight.  Of course there are some downsides to such a light cooler, check out how well it could cool a CPU over at Overclockers Club.

OCC_deepcool.jpg

"The thing that impressed me the most about this cooler, believe it or not, was its installation process. The 100% tool-free, in-case, no-rear-access-required installation went through like a breeze. It took only minutes to go from having no cooler to having this one installed. It's the first of its kind that is done this way and I hope other manufacturers take a step for lighter-end coolers that can get away without a heavy-duty mounting mechanism. The cooler's build quality is top notch, which follows in the steps of previous DEEPCOOL heat sinks that I have had the opportunity to review."

Here are some more Cases & Cooling reviews from around the web:

CASES & COOLING

 

Deepcool's tall and thin Ice Wind Pro heatsink

Subject: Cases and Cooling | May 10, 2012 - 06:07 PM |
Tagged: Deepcool, Ice Wind Pro

At 157mm tall the Deepcool Ice Wind Pro stands among the tallest heatsinks but at 86mm deep it is much thinner which also means its weight is lower, at 650g.  The heatpipes contact the CPU directly and FrostyTech's measurements show the contact area to be completely flat which is very important for the efficiency of the cooler.  The noise generated at low speeds is negligible and even when turned to high to give better cooling performance it is still not very loud.  At high speed the cooler does provide good cooling even though it for both AMD and Intel processors, even if it is very slim, so if you are building a system using RAM with tall heatspreaders then this cooler is very much worth considering.

FT_DCicewindpro_d.jpg

"Deepcool's Ice Wind Pro heatsink is a rather novel CPU cooler for two unique qualities; 1) its heatpipe-to-fin arrangement and 2) the geometry of its leading and trailing fin edges. First off, rather than clusters of heatpipes at the left and right sides of the aluminum fin tower, the eight ends of the heatpipes are lined up straight in a row, 10mm apart, right down the middle of the heatsink. Secondly, the leading/trailing edges of the aluminum fin stack have five large, slightly arc'd diamond cut-outs parallel to the direction of the fins that break up the otherwise monolithic wall."

Here are some more Cases & Cooling reviews from around the web:

CASES & COOLING

 

Source: Frosty Tech